RNA formaldehyde gels

From Tanaka Wiki
Revision as of 10:54, 27 March 2015 by Stephanh (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search


Prepare gel box:

  • Clean gel box and combs etc with detergent, then dionized water.
  • Then incubate the gel box and components in 10% H2O2 (hydrogen peroxide, stored in cold room) for 30 minutes.
  • Rinse box thoroughly with DEPC water.

For making gel and preparing samples:

  • Your should pour (and ideally run) the gel in the hood, since the gel contains formaldehyde. [see protocol from Maniatis (original edition)—attached.]

Running the gel:

Just before loading the samples:

  • Heat your samples (see step 3 Maniatis protocol) for 15 minutes at 65 or 70 C and then put immediately on ice. The add loading buffer (see step 4 Maniatis).
  • ALSO, pre-run the gel at 50 V for 10 minutes
    • Load samples.
    • For mini gels, run at 30V for 4-5 hours. (for best results place the gel on a bed of ice to keep it cold)
    • Stain in EtBr 1 hour to overnight ( 5 µl of 10 mg/ml solution per 50 ml DEPC water)
    • Destain in DEPC water for 1-2 hours (change water 2x during this time)
    • Take picture (Karla's lab has a good digital documentation system)