RNA formaldehyde gels: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| (One intermediate revision by the same user not shown) | |||
| Line 1: | Line 1: | ||
== Procedure == | == Procedure == | ||
=== Prepare gel box: === | === Prepare gel box: === | ||
* Clean gel box and combs etc with detergent, then dionized water. | |||
* Then incubate the gel box and components in 10% H2O2 (hydrogen peroxide, stored in cold room) for 30 minutes. | |||
* Rinse box thoroughly with DEPC water. | |||
=== For making gel and preparing samples: === | === For making gel and preparing samples: === | ||
* Your should pour (and ideally run) the gel in the hood, since the gel contains formaldehyde. [see protocol from Maniatis (original edition)—attached.] | |||
=== Running the gel: === | === Running the gel: === | ||
''Just before loading the samples:'' | |||
* Heat your samples (see step 3 Maniatis protocol) for 15 minutes at 65 or 70 C and then put immediately on ice. The add loading buffer (see step 4 Maniatis). | |||
* ALSO, pre-run the gel at 50 V for 10 minutes | |||
<ul> | <ul> | ||
* Load samples. | |||
* For mini gels, run at 30V for 4-5 hours. (for best results place the gel on a bed of ice to keep it cold) | |||
* Stain in EtBr 1 hour to overnight ( 5 µl of 10 mg/ml solution per 50 ml DEPC water) | |||
* Destain in DEPC water for 1-2 hours (change water 2x during this time) | |||
* Take picture (Karla's lab has a good digital documentation system) | |||
</ul> | </ul> | ||
Latest revision as of 10:54, 27 March 2015
Procedure
Prepare gel box:
- Clean gel box and combs etc with detergent, then dionized water.
- Then incubate the gel box and components in 10% H2O2 (hydrogen peroxide, stored in cold room) for 30 minutes.
- Rinse box thoroughly with DEPC water.
For making gel and preparing samples:
- Your should pour (and ideally run) the gel in the hood, since the gel contains formaldehyde. [see protocol from Maniatis (original edition)—attached.]
Running the gel:
Just before loading the samples:
- Heat your samples (see step 3 Maniatis protocol) for 15 minutes at 65 or 70 C and then put immediately on ice. The add loading buffer (see step 4 Maniatis).
- ALSO, pre-run the gel at 50 V for 10 minutes
- Load samples.
- For mini gels, run at 30V for 4-5 hours. (for best results place the gel on a bed of ice to keep it cold)
- Stain in EtBr 1 hour to overnight ( 5 µl of 10 mg/ml solution per 50 ml DEPC water)
- Destain in DEPC water for 1-2 hours (change water 2x during this time)
- Take picture (Karla's lab has a good digital documentation system)